Looking for other PCNC1100 owners to help this old man get rolling. 80 years old…
2 Likes
Happy to help what do you need first? I have an 1100MX but can probably help you with the basics.
Scott:
Thank you for the response. I’m a little ahead of myself to ask for help. The electric is in place for the machine and lighting I have yet to do. I still have to find space for everything piled up to make room for it. Likely two weeks to clear up the mess.
Where are you located? I’m in the south end of Fallbrook a couple of miles north of the 76.
Call if you like.
Bob Beecroft
760 419-5972
Some about my (hobby) interests here: www.theaerosmith.com
and direct, Bob@theaerosmith.com
Hi Bob,
I’m on the east coast. Just let us know when you’re ready there are plenty of people here that will help. I also strongly recommend looking at the Tormach YouTube channel as there is a lot of helpful content on there.
Hey, Scott, thanks!
I wasn’t aware of the YouTube channel and will look it up post-haste.
I have followed Saunders NYCNC some and just found Academy.Titansofcnc.com that looks promising.
I’ll be in touch. BTW, where are you on the east coast? I hope you aren’t having to deal with the terrible conditions reported on the Weather Channel.
Merry Christmas!
Bob
Hi Bob, those sites are good but the Titan stuff sometimes dead ends leaving you hanging. I do think the models are very good and if you do them in order they will help build your confidence and skills.
I’m currently in NH freezing my butt off! 
@Robert_Beecroft a while back I tried to make sense of all the YouTube content out there and made these lists. I always recommend these as a starting point.
1 Like