1100mx path pilot console. The cursor wanders throughout the day. If I calibrate it in the morning, by lunch it can be off by a couple mm or several inches. Also the more I calibrate the farther the cursor gets away from where I touch. I have been deleting the calibration file and rebooting a couple times a week but I want to lock in a calibration.
Dr Harold Jones,
What version of path pilot are you running? I would make sure you are updated to the most recent version. Then follow the steps below in order.
- In the file tab scroll down to pointercal.xinput and delete this file
- restart controller/computer
- skip when it asks to touch points
- in MDI type ADMIN TOUCHSCREEN SENSITIVITY 1000
- in MDI type admin touchscreen enter touch all 4 points with finger not mouse
Let me know if this fixes the issue.
Kindest regards,
Katie
1 Like
I tried the above response and it did fix it for a few hours. Ultimately I did a software restore on the pp console and the issue was resolved. It hasn’t been a problem since. Thanks.