Conversational threading complains about invalid RPM on post

PathPilot
1

I’m trying to set up a threading operation. When I post, PathPilot gives me an error saying the RPM is invalid: “Conversational Threading entry error - Invalid RPM settings 3. RPM must be between 180 and 2500 in present spindle config.”

I used the Plastic/Delrin setting in the conversational tab, and it put in 2500 for the RPM. Note that I am unable to edit the MPM/RPM fields, not sure why.

IMG_1294
IMG_12941920×2560 319 KB

IMG_1295
IMG_12951920×1440 249 KB

2

Oh geez, nevermind. I didn’t see the bright red RPM box in the upper-right, I was so focused on the stuff on the left.

1 Like