770M from 110 to 220VAC?

I wired my little shop for 220 in preparation for my Tormach 770M and Everlast TIG welder (and whatever else shows up over time.

I have two, independent 220v circuits/plugs. I put 50A/250v outlets on each (as that’s what my welder needed.

My understanding is that the 770M can be configured to utilize 220. Can someone walk me through whats necessary for the configuration? Or point me to some online instructions?

Do I need to change the outlet? Machine plug? Configure anything special on the board? Going to start pouring through the manual, now. During setup I noticed switching the pump… but I’m using a Fogbuster & it didn’t looking like anything in that section applied.

Any help is greatly appreciated.770

@Mike_Hansen The 770M is not able to be run on 220v. You can purchase 220 to 120 step down transformer to run your machine however.