Hello all, New to Pathpilot controls, and very used to programming parts by hand for a Haas using G71 and G70 canned cycles. On my new to me 15L, programs that worked on Haas lathes no longer work and I get error messages for the canned cycles. Any insights or work arounds would be greatly appreci…

Yes. You have to write the profile coordinates into a sub routine except throw it into parentheses. Here is a top I make frequently that was created in conversational. (----- Start of G-code -----) () G7 (Dia. Mode) G18 (XZ Plane) G90 (Absolute Distance Mode) G40 (Turn Cutter Compensation Off…

G71 and G70 in Pathpilot

Lathe

Davie November 8, 2025, 2:09am 2

We have a different adaptation of g71 than Haas. Check out this post

1 Like